Jenny Science XENAX Xvi 75V8S Instruction Manual page 108

Errors are displayed on the
7-segment display by flashing a two digit number.
With the command „>TE" (Tell Error) they can be
There are 3 different categories to differentiate:
The first information/warning/error is always displayed first. A possible follow-up error won't be displayed. Each
warning can overwrite information and each error can overwrite a warning or information. The error history can
be retrieved with AXII command TEB.
F-Number
01 to 12 Waiting for input xx (Low od. High)
20
21
22
23 Starting position of motion profile is not
24
25 Bus module supervision disabled
26 Third party motor not configurated or
27 Swing Out Reduction Parameter
XENAX® servo controller's
retrieved.
Information No 0-39
Warnings No 40-49
Errors No 50-99
Description
Command not allowed
Force license missing
Program start interrupted
valid
Index Paramater not valid
DIP-switch setting wrong
inconsistency
15 Error Handling
They do not change state of the servo controller. These are
simple status indicators.
They can trigger a stop of an active drive (e.g. driving in soft
limit). However, the drive can then be continued without the
need to switch off the output stage.
Always cause the output stage to switch off. The drive can
only be continued after troubleshooting.
15.1 Error Codes
Note
Information
Keeps driving, if status has been reached or restart with HO, REF,
SM, or PQ, PWC.
Command is not allowed, if an external PLC is controlling the axis.
The command priority of the overriding PLC can be deactivated if
the user set the CANopen Mode of operation to 0 (CANopen Object
0x6060)
Calibration value are existing in motor,
but there is no force license active
Program start is interrupted through input function "IP"
Motion profile (ASCII command "PRF") can only be started if linear
motor slide is positioned at or behind the starting position of the
motion profile.
One or more parameters of the most previous selected index are
not valid. Please check Acceleration (ASCII-command „AIX"), Speed
(ASCII-command „SIX") and type (ASCII-command „TYIX") of index.
Bus module is only intended for development purposes. Change
bus module by Jenny Science.
For Jenny Science Motors (LINAX/ELAX/ROTAX):
For all Jenny Science motors the DIP-switch has to be set on
„LINAX/ELAX/ROTAX".
For third party motors:
Please make correct setting for the motor in WebMotion® under
setup → motor.
A new calculation of the target trajectory for swing out reduction
feature can only be initialized after a motor standstill
-> Motor has to be at standstill for at least 1000ms so that a new
set of parameters can be used.
108