Powering Off The System - Silicon Graphics SGI Altix 3700 Bx2 User Manual

1: Operation Procedures

Powering Off the System

8
2. If you want to power on the bricks connected to the CR-brick, enter the following
command:
oo3c01-L1> * power up
(* indicates all)
3. From the L1 prompt, display the brick configuration information by entering the
following command:
001c05-L1> config
In L1 mode, you can obtain only limited information about the system
configuration. A CR-brick only has information about its attached I/O brick and, if
another CR-brick is attached to the I/O brick, information about that CR-brick and
its attached I/O brick. An I/O brick only has information about its attached
CR-brick and an R-brick only has information about itself.
The L1 controller display, located on the front of each brick, should display
once the power-on procedure starts.
You can power off individual bricks or your entire server system using either the system
console interface or the L1 controller of the primary CR-brick.
L1 running
007-4377-002