Figure 6-4 Menu 11.3 - Applying Nat To The Remote Node; Table 6-3 Applying Nat In Menus 4 & 11.3 - ZyXEL Communications ZyXEL ZyWALL 50 User Manual

Step 2. Move the cursor to the Edit IP field, press [SPACE BAR] to select Yes and then press
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.
[ENTER] to bring up Menu 11.3 - Remote Node Network Layer Options.
Figure 6-4 Menu 11.3 — Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
FIELD OPTIONS
Network Full
Address Feature
Translation
None
SUA Only
NAT
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA Only
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Table 6-3 Applying NAT in Menus 4 & 11.3
When you select this option the SMT will use Address Mapping Set 1
(menu 15.1 - see section 6.3.1 for further discussion). You can configure
any of the mapping types described in Table 6-2. Choose Full Feature if
you have multiple public WAN IP addresses for your ZyWALL.
NAT is disabled when you select this option.
When you select this option the SMT will use Address Mapping Set 255
(menu 15.1 - see section 6.3.1). Choose SUA Only if you have just one
public WAN IP address for your ZyWALL.
ZyWALL 50 Internet Security Gateway
DESCRIPTION
6-7