Pppoe Encapsulation - ZyXEL Communications ZyXEL ZyWALL 50 User Manual

FIELD
My Password Enter the password assigned by your ISP when the ZyWALL calls
this remote node. Valid for PPPoE encapsulation only.
Server IP This field is valid for RoadRunner service type only. The ZyWALL
will find the RoadRunner Server IP automatically if this field is left
blank. If it does not, then you must enter the authentication server
IP address here.
Route This field refers to the protocol that will be routed by your
ZyWALL – IP is the only option for the ZyWALL 50.
Edit IP This field leads to a "hidden" menu. Press [SPACE BAR] to select
Yes and press [ENTER] to go to Menu 11.3 - Remote Node
Network Layer Options.
Session Options This field leads to another "hidden" menu. Use [SPACE BAR] to
select Yes and press [ENTER] to open menu 11.5 to edit the filter
Edit Filter sets
sets. See the Remote Node Filter section for more details.
Once you have configured the Remote Node Profile Menu, press [ENTER] to return to menu 11. Press
[ENTER] at the message "Press ENTER to Confirm..." to save your configuration, or press [ESC] at any
time to cancel.

4.1.2 PPPoE Encapsulation

The ZyWALL supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use PPPoE
encapsulation when you're using the ZyWALL with an xDSL modem as the WAN device. If you change
the Encapsulation to PPPoE, then you will see the next screen. Please see the Appendices for more
information on PPPoE.
Remote Node Setup
Table 4-1 Fields in Menu 11.1
DESCRIPTION
ZyWALL 50 Internet Security Gateway
EXAMPLE
*****
IP
Yes
Yes
4-3