Restore Using Ftp Session Example; Restore Via Console Port; Figure 18-8 Restore Using Ftp Or Tftp Session Example; Figure 18-9 System Maintenance - Restore Configuration - ZyXEL Communications ZyXEL ZyWALL 50 User Manual

Step 3. Press [ENTER] when prompted for a username.
Step 4.
Enter your password as requested (the default is "1234").
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6. Find the "rom" file (on your computer) that you want to restore to your ZyWALL.
Step 7. Use "put" to transfer files from the Prestige to the computer, for example, "put config.rom rom-
0" transfers the configuration file "config.rom" on your computer to the Prestige. See earlier in
this chapter for more information on filename conventions.
Step 8.
Enter "quit" to exit the FTP prompt. The ZyWALL will automatically restart after a successful
restore process.

18.3.3 Restore Using FTP Session Example

Figure 18-8 Restore Using FTP or TFTP Session Example

Refer to section 18.2.5 to read about configurations that disallow TFTP and FTP over WAN.

18.3.4 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.6 and enter "y" at the following screen.
Figure 18-9 System Maintenance — Restore Configuration
Step 2. The following screen indicates that the Xmodem download has started.
Firmware and Configuration File Maintenance
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
ZyWALL 50 Internet Security Gateway
18-9