Editing Tcp/Ip Options (With Pppoe Encapsulation); Remote Node Filter - ZyXEL Communications ZyXEL ZyWALL 50 User Manual

ZyWALL 50 Internet Security Gateway
Table 4-5 Remote Node Network Layer Options Menu Fields
FIELD
Metric The metric represents the "cost" of transmission for routing purposes.
IP routing uses hop count as the measurement of cost, with a
minimum of 1 for directly connected networks. Enter a number that
approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Private This parameter determines if the ZyWALL will include the route to
this remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
broadcasts.
RIP Press [SPACE BAR] to select the RIP direction from Both/ None/In
Only/Out Only and None.
Press [SPACE BAR] to select the RIP version from RIP-1/RIP-
Version
2B/RIP-2M.
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The ZyWALL
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
Press the [SPACE BAR] to enable IP Multicasting or select None to
disable it. See the previous Part for more information on this feature.
Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to menu 11.
Press [ENTER] at the message "Press ENTER to Confirm..." to save your configuration, or press [ESC] at
any time to cancel.

4.2.2 Editing TCP/IP Options (with PPPoE Encapsulation)

Make sure Encapsulation is set to PPPoE in menu 11.1. Move the cursor to the Edit IP field in Menu
11.1 and press [SPACE BAR] to select Yes. Press [ENTER] to open Menu 11.3 - Network Layer
Options. The menu and fields are the same as described for PPTP encapsulation above.
4.3

Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.1, then press [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
4-10
DESCRIPTION EXAMPLE
1 to 15
Yes
None
(default)
RIP-1
None
Remote Node Setup