ZyWALL 50 Internet Security Gateway
The following table describes the SNMP configuration parameters.
FIELD
Get
Enter the Get Community, which is the password for the incoming Get-
Community
and GetNext- requests from the management station.
Set Community
Enter the Set Community, which is the password for incoming Set-
requests from the management station.
Trusted Host
If you enter a trusted host, your ZyWALL will only respond to SNMP
messages from this address. If you leave the field set to 0.0.0.0
(default), your ZyWALL will respond to all SNMP messages it receives,
regardless of source.
Trap:
Enter the trap community, which is the password sent with each trap to
Community
the SNMP manager.
Trap:
Enter the IP address of the station to send your SNMP traps to.
Destination
Once you have completed filling in Menu 22 - SNMP Configuration, press [ENTER] at the message
"Press ENTER to Confirm" to save your configuration, or press [ESC] to cancel.
16.4 SNMP Traps
The ZyWALL will send traps to the SNMP manager when any one of the following events occurs:
16-4
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Figure 16-2 Menu 22 — SNMP Configuration
Table 16-2 SNMP Configuration Menu Fields
DESCRIPTION
DEFAULT
public
(default)
public
(default)
0.0.0.0
(default)
public
(default)
0.0.0.0
(default)
SNMP