Procedure To Use The Reset Button - ZyXEL Communications ZyXEL ZyWALL 50 User Manual

3.4.2 Procedure To Use The Reset Button

Make sure the SYS led is on (not blinking) before you begin this procedure.
1. Press the RESET button for ten seconds, then release it. If the SYS LED begins to blink, the
defaults have been restored and the ZyWALL restarts. Otherwise, go to step 2.
2. Turn the ZyWALL off.
3. While pressing the RESET button, turn the ZyWALL on.
4. Continue to hold the RESET button. The SYS LED will begin to blink and flicker very quickly
after about 10 or 15 seconds. This indicates that the defaults have been restored and the ZyWALL
is now restarting.
5. Release the RESET button and wait for the ZyWALL to finish restarting.
Initial Setup
ZyWALL 50 Internet Security Gateway
3-9