ZyWALL 50 Internet Security Gateway
Press Space Bar to Toggle.
Use the instructions in the following table to configure IP Alias parameters.
FIELD
IP Alias
Choose Yes to configure the LAN network for the ZyWALL.
IP Address
Enter the IP address of your ZyWALL in dotted decimal notation.
IP Subnet Mask Your ZyWALL will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyWALL.
RIP Direction
Press [SPACE BAR] to select the RIP direction. Options are:
Both, In Only, Out Only or None.
Version Press [SPACE BAR] to select the RIP version. Options are:
RIP-1, RIP-2B or RIP-2M.
Incoming
Enter the filter set(s) you wish to apply to the incoming traffic
Protocol Filters
between this node and the ZyWALL.
Outgoing
Enter the filter set(s) you wish to apply to the outgoing traffic between
Protocol Filters
this node and the ZyWALL.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm...] to save
your configuration, or press [ESC] at any time to cancel.
5-8
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
Figure 5-7 Menu 3.2.1 — IP Alias Setup
Table 5-5 IP Alias Setup Menu Fields
DESCRIPTION
EXAMPLE
Yes
192.168.2.1
255.255.255.0
None
RIP-1
1
2
LAN Setup