Nat Setup; Figure 160 Menu 11.3: Applying Nat To The Remote Node; Table 124 Applying Nat In Menus 4 & 11.3 - ZyXEL Communications P-793H User Manual

Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes and
3
then press [ENTER] to bring up Menu 11.3 - Remote Node Network Layer
Options.

Figure 160 Menu 11.3: Applying NAT to the Remote Node

IP Options:
IP Address Assignment = Static
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
IP Policies=
The following table describes the fields in this menu.
Table 124 Applying NAT in Menus 4 & 11.3
FIELD
Network
Address
Translation

30.2 NAT Setup

Use the address mapping sets menus and submenus to create the mapping table
used to assign global addresses to computers on the LAN and the DMZ. Set 255 is
used for SUA. When you select Full Feature in menu 4 or menu 11.3, the SMT will
use the address mapping set that you specify. When you select SUA Only, the SMT
will use the pre-configured Set 255 (read only).
P-793H v2 User's Guide
Menu 11.3 - Remote Node Network Layer Options
DESCRIPTION
When you select this option the SMT will use the specified
address mapping set (menu 15.1 - see
342 for further discussion). You can configure any of the
mapping types described in
Feature if you have multiple public WAN IP addresses for your
P-793H v2.
When you select Full Feature you must configure at least one
address mapping set.
NAT is disabled when you select this option.
When you select this option the SMT will use Address Mapping
Set 255 (menu 15.1 - see
SUA Only if you have just one public WAN IP address for your P-
793H v2.
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Section 30.2.1 on page
Chapter 8 on page 117. Choose Full
Section 30.2.1 on page 342). Choose
Chapter 30 NAT Setup
OPTIONS
Full
Feature
None
SUA Only
341