Appendix G Firewall Cli Commands - ZyXEL Communications ZyXEL ZyWALL 50 User Manual

The following table describes the syntax used to configure your firewall using Command Line Interface
(CLI) commands. Select Menu 24.8 - Command Interpreter Mode from the main menu to go into CLI
mode. For details on other CLI commands to configure your ZyWALL, please consult the included disk.
FUNCTION
F F i i r r e e w w a a l l l l
S e t - U p
S e t - U p
config edit firewall active <yes
| no>
config retrieve firewall
config save firewall
D i s p l a y
D i s p l a y
config display firewall
config display firewall set <set
#>
config display firewall set <set
#> rule <rule #>
config display firewall attack
config display firewall e-mail
config display firewall ?
E E d d i i t t
E - m a i l
E - m a i l
config edit firewall e-mail mail-
server
<ip address of mail server>
config edit firewall e-mail
return-addr
<e-mail address>
Firewall CLI Commands
Firewall CLI Commands
CLI SYNTAX
ZyWALL 50 Internet Security Gateway
Appendix G
DESCRIPTION
Activates or deactivates the saved firewall settings.
Retrieves currently saved firewall settings.
Saves the current firewall settings.
Displays the all the firewall settings including e-mail, attack,
and sets/rules.
Displays current entries of a set configuration; including
timeout values, name, default-permit, and number of rules
under it.
If you don't put # after set, it will display all the sets/rules
information.
Displays current entries of a rule in a set configuration;
Displays all the settings for attack alert.
Displays all the setting for e-mail part.
Displays all the available sub commands.
Edits the mail server which alerting e-mail messages are
sent through.
Edits the source address for sending mail usage.
M