Priming - Taylor 60 Operator's Manual

5. Press the far right button on the syrup selector switch
(VAN). Place the control switch in the WASH position.
This will allow the solution to agitate in the freezing
cylinder. Allow the solution to agitate for 
5 minutes.
Figure 6-28
6. Place an empty pail beneath the spinner housing and
raise the draw arm. Draw off all the sanitizing
solution. When the solution stops flowing from the
spinner housing, lower the draw arm and place the
control switch in the OFF position.
Important! The machine must not be placed in
AUTO until all sanitizing solution has been removed
from the freezing cylinder and proper priming
procedures have been completed. Failure to follow
this instruction may result in damage to the freezing
cylinder.
Figure 6-29
7. Stand the feed tube in the corner of the mix hopper.
Operating Procedures

Priming

1. Make sure the syrup selector switch is in the OFF
position (VAN).
2. With a pail beneath the spinner housing, raise the
draw arm. Pour 2 gal. (7.6 L) of fresh mix into the mix
hopper and allow it to flow down into the freezing
cylinder. This will force out any sanitizing solution.
When full-strength mix is flowing from the spinner
housing, lower the draw arm. Discard the remaining
sanitizing solution.
Important! Failure to remove all sanitizing solution
may result in damage to the freezing cylinder.

When the mix has stopped bubbling down into the
freezing cylinder, install the feed tube in the mix inlet

hole. During AUTO operation, make sure the end of
the feed tube with the hole in it is submerged in the
mix.
Models 60 and 62
OPERATING PROCEDURES
Figure 6-30
Figure 6-31
6
6-7