Taylor 60 Operator's Manual page 23

7. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: door
bearing, door gasket, draw valve, O-rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
8. Install the draw valve. Lubricate the plastic spinner
bearing. Insert the plastic spinner bearing into the top
of the draw valve.
Figure 6-9
Slide the two O-rings onto the draw valve and 
lubricate.
Figure 6-10
Operating Procedures
9. Lubricate the inside of the door spout, top and
bottom. Insert the draw valve into the freezer door
from the top. It will be necessary to rotate the draw
valve bracket to the right to allow installation of the
freezer door.
10. Place the large rubber gasket into the groove on the
back side of the freezer door. Do not lubricate the
gasket.
Models 60 and 62
OPERATING PROCEDURES
Figure 6-11
Figure 6-12
6
6-3