Taylor 60 Operator's Manual page 40

TROUBLESHOOTING GUIDE
Problem
4. Large pressure
adjustments are
necessary to receive 
1 oz. (29.6 ml.) in 
6 seconds.
5. The mix hopper is too
warm.
6. The mix hopper is too
cold.
7. Machine short cycling
(rapid on and off cycles).
8. The freezing cylinder
walls are scored.
9. The driveshaft is stuck in
the gearbox coupling.
8
10.Excessive mix leakage
into the rear drip pan.
8-2
Probable Cause
a. Hardened syrup in syrup line.
b. Syrup line and air line not matched
properly to syrup tank.
a. Product too warm when placed in
hopper.
b. Control switch in the OFF position.
c. The temperature is out of
adjustment.
a. The temperature is out of
adjustment.
b. Dirty air-cooled condenser.
c. Inadequate water supply on 
water-cooled unit.
d. Defective condenser fan.
e. No airspace surrounding machine.
a. The scraper blades are damaged.
b. Machine was placed in AUTO
before all sanitizing solution was
removed from freezing cylinder.
c. The front bearing is missing or
worn on the freezer door.
d. The beater assembly is bent.
e. The beater pins are broken.
a. Lubrication on hex end of shaft.
b. Rounded corners of hex end of
driveshaft.
a. Rounded corners of coupling on
gearbox.
a. Worn or missing seal on driveshaft.
b. Inadequate lubrication of
driveshaft.
c. Bad rear shell bearing.
d. Driveshaft and beater working
forward.
Models 60 and 62
Remedy
a. Sanitize syrup lines once a week.
b. Match syrup and air lines to syrup
tank.
a. Check temperature in storage cooler.
b. Place in AUTO position.
c. Call a service technician to adjust
hopper temperature.
a. Call a service technician to adjust
hopper temperature.
b. Brush-clean every 30 days.
c. Check water supply.
d. Call service to repair or replace.
e. Maintain specified air clearance.
a. Replace the scraper blades.
b. Place machine in AUTO only after
priming is complete and all sanitizing
solution is removed.
c. Install or replace the front bearing.
d. Call a service technician to repair or
replace beater and to correct cause of
insufficient mix in freezing cylinder.
e. Call service technician to repair or
replace.
a. Call service techician for removal.
b. Replace defective driveshaft.
a. Call service technician to replace
gearbox.
a. Replace every 3 months.
b. Follow lubrication procedures in
Assembly on page 6-1.
c. Call service technician to replace rear
shell bearing.
d. Call service technician.
Page
Ref.
6-14
6-9
7-1
6-8
- - -
- - -
7-2
1-2
- - -
1-1
6-2
6-7
6-4
- - -
- - -
- - -
- - -
- - -
9-1
6-2
- - -
- - -
Troubleshooting Guide