Consistency Control
The viscosity (thickness) of the shake is controlled by a
sensing device called the consistency control. The
consistency control knob is below the control switch. To
achieve a thicker shake, turn the knob clockwise. For a
thinner shake, turn the knob counterclockwise.
The refrigeration system must cycle on and off two or
three times before an accurate consistency can be
evaluated.
See Figure 5-1 on page 5-1.
Spinner Rinse Switch
The spinner rinse switch is next to the consistency
control knob. To clean syrup residue from the spinner
housing:
1. Place the control switch in the AUTO position.
2. Hold a cup under the spinner housing.
3. Press the spinner rinse switch. Water will flow until
the switch is released.
4. Release the switch when the housing has been
thoroughly rinsed.
See Figure 5-1 on page 5-1.
Auto Lift Switch (Model 60 Only)
The auto lift switch is below the flavor selector switch.
The auto lift switch may be used to draw product. Press
the switch. Just before the desired level in the cup is
reached, release the switch. The draw arm will lower the
draw valve and the product will stop flowing.
See Figure 5-1 on page 5-1.
User Interface
Foot Pedal (Model 60 Only)
The foot pedal is on the lower front of the machine. The
foot pedal may be used to draw product from the Model
60. Press the foot pedal. Just before the desired level in
the cup is reached, release the foot pedal. The draw arm
will lower the draw valve and the product will stop
flowing.
Flavor Selector Switch
The flavor selector switch consists of four flavor buttons.
The left button (CHERRY) controls the No. 1 tank and its
lines. The second button (STRAW) from the left controls
the No. 2 tank and its lines. The third button (CHOC) from
the left controls the No. 3 tank and its lines. The right
selector button (VAN) is the Off button and may be used
to dispense unflavored product as a vanilla shake.
See Figure 5-1 on page 5-1.
Models 60 and 62
USER INTERFACE
Figure 5-3
5
5-3