Section 6: Operating Procedures; Assembly - Taylor 60 Operator's Manual

Section 6
The Models 60 and 62 have one 7 quart (6.6 liter)
freezing cylinder. These totally automatic freezers offer
four separate flavors. Each flavor is blended and ejected
from the same spout. (Use only single-strength syrup that
is free of pulp and seeds.)
We begin our instructions at the point when we enter the
store in the morning and find the parts disassembled and
laid out to air-dry from the previous night's 
brush-cleaning.
These opening procedures will show you how to
assemble these parts into the freezer, sanitize them, and
prime the freezer with fresh mix in preparation to serve
your first shake.
Figure 6-1
If you are disassembling the machine for the first time or
need information to get to this point in the instructions,
turn to Disassembly on page 6-13.

Assembly

Note: When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
WARNING! Make sure the power switch is in
the OFF position before installing/removing any parts.
Failure to follow this instruction may result in severe
personal injury or electrocution.
Make sure your hands are sanitized before
assembling the freezer.
Operating Procedures
Operating Procedures
1. Installing the driveshaft: Lubricate the groove and
shaft portion of the beater driveshaft that comes in
contact with the bearing on the beater driveshaft.
Slide the driveshaft seal over the shaft and groove
until it snaps into place. Do not lubricate the hex
end of the driveshaft.
Fill the inside portion of the seal with 1/4 in. 
(6.35 mm) more lubricant. Lubricate the flat side of
the seal that comes in contact with the bearing.
Note: Make sure the seal is not installed inside out.
The ridge that protrudes at the center of the seal should
be on the outside.
2. Install the driveshaft into the freezing cylinder, hex
end first, and into the rear shell bearing until the seal
fits securely over the rear shell bearing. Make sure
the driveshaft fits into the drive coupling without
binding.
Models 60 and 62
Figure 6-2
Figure 6-3
6
6-1