Taylor 60 Operator's Manual page 25

14. Locate the spinner coupling and slip it over the
slotted end of the spinner blade shaft. Raise the slip
collar on the coupling and turn the shaft from the
bottom until the spinner coupling slips down into its
locking position.
Figure 6-18
Rotate the draw valve to the left and center it on the
draw arm. Place the draw arm into the slotted groove
of the draw valve bracket.
Figure 6-19
15. Install the torque arm. Position the torque arm by
slipping it up through the slot in the operating arm.
Then align the other end down in the hole in the
torque rotor shaft, which protrudes from the door.
Operating Procedures
Check the torque arm by moving it back and forth to
make sure it moves freely and easily.
16. Connect the syrup lines. Connect the syrup lines of
the spinner housing to the quick disconnect fittings
on the front panel.
Models 60 and 62
OPERATING PROCEDURES
Figure 6-20
Figure 6-21
Figure 6-22
6
6-5