Taylor 60 Operator's Manual page 24

OPERATING PROCEDURES
Slide the white plastic front bearing onto the bearing
hub. Make certain that the flanged end of the bearing
is resting against the freezer door. Do not lubricate
the front bearing.
11. Install the freezer door. Locate the torque rotor in the
center hole of the freezer door. Position the door on
the four studs on the front of the freezing cylinder and
firmly push it into place. Install the four handscrews
on the studs and finger-tighten equally in a crisscross
pattern to ensure the door is snug. Do not
overtighten.
6
6-4
Figure 6-13
Figure 6-14
12. Install the drip pan into the hole in the front panel.
13. Install the spinner housing. Snap the plastic spinner
housing onto the bottom of the door spout.
Lubricate the spinner blade shaft and insert the 
spinner blade from the bottom into the center of the
draw valve.
Models 60 and 62
Figure 6-15
Figure 6-16
Figure 6-17
Operating Procedures