Taylor 60 Operator's Manual page 12

SAFETY
WARNING! DO NOT use a water jet to clean
or rinse the machine. Failure to follow these instructions
may result in serious electrical shock.
WARNING! Avoid injury.
• DO NOT allow untrained personnel to operate
this machine.
• DO NOT operate the machine unless all service
panels and access doors are fastened with
screws.
• DO NOT remove any internal operating parts
3
(including, but not limited to the freezer door,
beater, or scraper blades) unless all control
switches are in the OFF position.
Failure to follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING! This machine has many sharp
edges that can cause severe injuries.
• DO NOT put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
• USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very
sharp.
Failure to follow these instructions can result in personal
injury or damage to the machine.
IMPORTANT! Access to the service area of
the machine must be restricted to persons having
knowledge and practical experience with the machine, in
particular as far as safety and hygiene are concerned.
CAUTION! This machine must be placed on a
level surface. Use caution when moving the machine.
Failure to comply may cause the machine to tip over and
result in personal injury.
3-2
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this machine.
CAUTION! This machine is designed to
maintain product temperature under 41°F (5C). Any
product being added to this machine must be below 41F
(5C). Failure to follow this instruction may result in
health hazards and poor machine performance.
Do not obstruct air intake and discharge openings:
Counter Models: 6" (152 mm) minimum airspace on both
sides. Place the rear of the machine against the wall to
prevent recirculation of warm air.
Console Models: 3" (76 mm) minimum airspace on each
side and rear of machine when air deflector is employed.
Failure to allow adequate clearance can reduce the
refrigeration capacity of the freezer and possibly cause
permanent damage to the compressor.
For Indoor Use Only: This machine is designed to
operate indoors, under normal ambient temperatures of 
70ºF to 75ºF (21ºC to 24ºC). The freezer has
successfully performed in high ambient temperatures of
104ºF (40ºC) at reduced capacities.
Do not run the machine without product. Failure to follow
this instruction can result in damage to the machine.
Noise Level: Airborne noise emission does not exceed
78 dB(A) when measured at a distance of 
39 in. (1.0 m) from the surface of the machine and at a
height of 63 in. (1.6 m) from the floor.
Models 60 and 62
Safety