Taylor 60 Operator's Manual page 41

Problem
11.Machine will not operate
when control switch is in
the AUTO position.
12.Water continues to flow
through spinner
housing.
13.Lift motor continues to
raise draw valve after
draw of product has
been made.
14.Air compressor runs too
often for normal usage.
15.Spinner shaft will not
rotate to blend syrup into
product.
16.Excessive drippage of
product from spinner
housing.
Troubleshooting Guide
Probable Cause
a. Draw arm not raised.
b. Circuit breaker off or blown fuse.
c. Beater motor out on reset.
d. Water turned off (water-cooled
machines).
a. Machine unplugged.
a. Rinse solenoid stuck open.
a. Micro switch needs adjustment.
a. Air leak in system.
a. Flexible cable broken.
b. Pin missing in female quick
disconnect.
a. Spinner motor out on thermal
overload.
a. The draw valve O-rings are worn or
missing.
b. Wrong O-rings on draw valve.
c. Inadequate lubrication of spinner
shaft.
Models 60 and 62
TROUBLESHOOTING GUIDE
Remedy
a. Raise draw arm momentarily to
activate system.
b. Turn circuit breaker on or replace
fuse.
c. Clear the tone and reset freezer.
d. Re-establish water supply.
a. Plug into wall receptacle.
a. Call service technician for repair.
a. Call service technician for repair.
a. Use a soap solution to locate the leak.
a. Call service technician to replace
cable.
b. Call service technician to replace
disconnect.
a. Inadequate lubrication of spinner
shaft. Lubricate entire length of shaft.
a. Replace every 3 months.
b. Check O-ring size.
c. Follow lubrication procedures in
Assembly.
Page
Ref.
6-8
- - -
5-2
1-2
- - -
- - -
- - -
- - -
- - -
- - -
6-5
9-1
- - -
6-5
8
8-3