Reading Configuration Barcodes - Datalogic Gryphon I GD4100 Product Reference Manual

Configuration Using Barcodes

Reading Configuration Barcodes

To program features:
1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each pro-
2. Scan the barcode to set the desired programming feature. You may need to cover unused
3. If additional input parameters are needed, go to
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
For detailed descriptions, programming information and examples for setting selected
configuration items, see
38
You must first enable your reader to read barcodes in order to use this
section. If you have not done this, go to
complete the appropriate procedure.
gramming page, when applicable.
barcodes on the page, and possibly the facing page, to ensure that the reader reads only the
barcode you intend to scan.
priate characters from the keypad.
Additional information about many features can be found in the "Refer-
ences" chapter.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
MING barcode to exit Programming Mode.
References, starting on page
Setup, starting on page 17
Appendix D, Keypad, and scan the appro-
285.
Gryphon™ I GD4100/GM4100/GBT 4100/L GD4300
and