Data Editing - Datalogic Gryphon I GM440 Series Product Reference Manual

References
2. Go to the Set Length page for your selected symbology and scan the
3. Scan the bar code to SELECT LENGTH 2 SETTING for your selected sym-
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure.

Data Editing

CAUTION
When a bar code is scanned, additional information can be sent to the host
computer along with the bar code data. This combination of bar code data
and supplementary user-defined data is called a "message string." The Data
Editing features can be used to build specific user-defined data into a mes-
sage string.
There are several types of selectable data characters that can be sent before
and after scanned data. You can specify if they should be sent with all sym-
bologies, or only with specific symbologies. Figure 1 shows the available
elements you can add to a message string:
Figure 1. Breakdown of a Message String
Prefix
276
ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
bology.
that represent the length setting which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake, before the last character scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
It is not recommended to use these features with IBM interfaces.
Label ID Transmission:
Enable this option to
transmit the Label ID you
configure for the scanned
symbology.
Label ID AIM ID Bar Code Data
AIM ID: This function is used to identify and display the
common label identifier for its symbology. When enabled,
this ID code will be transmitted before the scanned bar
code data.
00 - 20 Characters (ASCII)
Gryphon™ I GD44XX/GBT4400/GM440X
Appendix D, Keypad
OR...
Label ID Suffix