Table 5-5 Combination Settings Of The Et St.no. (Ethernet Station Number Setting) Switch; Table 5-6 Led Specifications - Hitachi S10VE User Manual

Table 5-5 Combination settings of the ET ST.No. (Ethernet station number setting) switch

Setting value
No.
U L
1 F F
2 Other than the
above
(5) LED specifications
Name Color
RUN Green
ALARM Red
ERR Red
STBY Green
LINK1 Green
LINK2 Green
ACT1 Green
ACT2 Green
For details about the operating status of the CPU unit that each combination of LEDs represents, see Chapter 11.
Operation.
The Ethernet ports operate using the following fixed IP addresses:
CH1: 192.192.192.1
CH2: 192.192.193.1
The Ethernet ports operate using the IP addresses you have set.
For details about how to set IP addresses, see 8.4.2.5 Network configuration.

Table 5-6 LED specifications

An LED that indicates the operating status of the ladder program.
This LED is lit when the ladder program is running.
An LED that indicates that an issue of some kind has occurred. This might be a drop in the
capacity of the primary battery, an issue with an option module, or a minor failure (including
both major and minor failures of option modules).
An LED that indicates the major failure status of the system. This LED is lit when a major
failure has occurred.
An LED indicating whether the CPU is in a standby state.
This LED is lit when the CPU is in a standby state.
An LED indicating the status of the physical connection between the ET1 port and its peer.
This LED is lit when a physical link is established.
An LED indicating the status of the physical connection between the ET2 port and its peer.
This LED is lit when a physical link is established.
This LED is lit when data is being transferred between the ET1 port and its peer.
This LED is lit when data is being transferred between the ET2 port and its peer.
Description
Specification
5-7
5. Part Names and Functions