Network Configuration Of Cpu Built-In Ethernet; Figure 8-30 Set Network Window - Hitachi S10VE User Manual

8. Tools

8.4.2.5.1 Network configuration of CPU built-in Ethernet

Set the network information of the CPU module.
If you intend to use only one Ethernet channel, use Ethernet 1. However, you must also set up Ethernet 2 so
that the PADT can connect to the CPU module to perform maintenance.
When using two Ethernet channels for control purposes, you will need to reconfigure Ethernet 1 or Ethernet
2 if the need arises to connect the PADT via the CPU built-in Ethernet.
If the same port is used for control and for connecting the PADT, the performance on the control side is
affected. For this reason, we recommend that you provide a dedicated port for PADT connection.
(1) From the main menu, select Project, Set Network, and then Ethernet.
(2) The Set Network window appears. Select the network you want to configure from the Select Network
drop-down list. The settings registered in the CPU module appear.

Figure 8-30 Set Network window

8-32