Adding An Fl.net Module - Hitachi S10VE User Manual

14.7.3 Adding an FL.NET module

(1) Make a note of the information displayed on the indicator of the CPU module, and whether each of its
LEDs(RUN, ALARM, STBY, ERR) is on, off, or blinking.
(2) Slide the LADDER RUN/STOP switch on the CPU module from RUN to STOP, and confirm that
LDRSTP appears on the indicator.
(3) Use the RAS menu in BASE SYSTEM/S10VE to save the CP and HP error log information for the CPU
module. For details on how to save this information, see 8.4.6.2 RAS menu: Error Log Display.
(4) Slide the CPU RUN/STOP switch on the CPU module from RUN to STOP, and confirm that CPUSTP
appears on the indicator.
(5) Turn off the power switch of the power supply module.
(6) Mount the FL.NET module to the mount base, and tighten the module fixing screws(M4) at the top and
bottom of the FL.NET module(tightening torque: 1.0 N·m).
(7) Set the MAIN/SUB setting switch on the FL.NET module. For details on how to set this switch, see the
S10VE User's Manual Option FL.NET (LQE702-E) (manual number SEE-1-104). Make sure that the
setting of the MAIN/SUB setting switch does not conflict with those of other FL.NET modules.
(8) Turn on the power switch of the power supply module.
(9) Set the CPU RUN/STOP switch of the CPU module to RUN.
(10) Start BASE SYSTEM/S10VE, and set up the FL.NET module you added. For details on how to set up a
new FL.NET module, see the S10VE User's Manual Option FL.NET (LQE702-E) (manual number SEE-
1-104).
(11) Turn off the power switch of the power supply module.
(12) Connect the cables to the connectors of the FL.NET module.
(13) Turn on the power switch of the power supply module.
(14) Set the LADDER RUN/STOP switch on the CPU module to RUN.
(15) Confirm that the state of the LEDs on the FL.NET module is as follows:
RUN LED: On
LER LED: On
ERR LED: Off
(16) Back up the data on the PCs. For details on how to back up the data on the PCs, see 14.11.1 Backup
procedure.
14-21
14. Adding and Replacing Modules