Ethernet Parameters Setting Error Code - Hitachi EH-150 Applications Manual

5.2.8

Ethernet parameters setting error code

The list of error code of Ethernet parameters setting is shown in Table 5.8.
Table 5.8
Error
Display comment
Code
Operation mode: Is not Configuration mode.
1001
Own station address: IP address is incorrect.
1101
Own station address: Subnet mask is
1102
incorrect.
Own station address: Default Gateway
1103
address is incorrect.
Own station address: IP address or Subnet
1104
mask is incorrect.
Test mode: IP address is incorrect.
1201
Test mode: Port No. is incorrect.
1202
Test mode: Port No. is in conflict with ASR
1203
(*1)
connection m
Task code communication (No. p
1301
No. is incorrect.
Task code communication: Timeout is
1303
incorrect.
Task code communication: Port No. conflict
1305
with ASR connection m
The setting of Transfer Speed / Type is
1306
incorrect.
*1: m should be in 1 to 6.
*2: p should be in 1 to 4.
Chapter 5 Configuration of Communication parameters
The list of error code during the IP address setting
.
(*2)
): Port
(*1)
.
5-10
Causes
The position of dip switch is not for "Configuration mode".
- Illegal value or character is set for IP address.
- "0.0.0.0" or "255.255.255.255" is set for IP address.
- Illegal value or character is set for Subnet mask.
- The out of value of "255.0.0.0" to "255.255.255.248" is set
for Subnet mask.
- Illegal value or character is set for Default gateway address.
- "255.255.255.255" is set for Default gateway address.
"255.255.255.255" is set for Subnet mask..
"0.0.0.0" or "255.255.255.255" is set for IP address of other
station for Diagnosis.
Illegal value or character is set for port number of other
station for Diagnosis.
The port number of other station for Diagnosis and the port
number of ASR connection m
Illegal value or character is set for task code port number.
Illegal value or character is set for task code time out
number.
The port number of task code and the port number of ASR
(*1)
connection m is in coincidence (conflict).
The setting of Transfer Speed / Type is out of valid range.
(*1)
is in coincidence(conflict).