Table of Contents
Advertisement
8. Tools
Select the number of the module whose parameters you want to set, and then click OK.
The network information you set in the Set Network (ET.NET) window is written to the selected
module.
If you click Cancel, you are returned to the Set Network (ET.NET) window without any settings
being written to the PCs.
If network information is already set for the selected module, a message appears asking you to
confirm that you want to overwrite the information.
Figure 8-38 Overwrite confirmation message
To overwrite the existing settings, click OK. The system writes the new settings to the PCs. If you do
not want to overwrite the existing settings, click Cancel. You will be returned to the Option module
parameter setup list window (Figure 8-37) without any settings being written to the PCs.
You cannot apply the same network settings to more than one option module.
If the same settings are already applied to an option module, a message appears that notifies you of
this fact and asks you if you want to clear the settings.
Figure 8-39 Message confirming removal of duplicate settings
If you click OK, the system writes the network information you input to the selected option module,
and removes the settings from the option module to which the settings were already applied.
If you click Cancel, the system does not write the network information to the selected module.
8-38
Advertisement
Table of Contents
Troubleshooting
