State Signal Timing; Pcsok Signal; Figure 11-12 Output Timing Of The Pcsok Signal (From Stop To Run); Figure 11-13 Output Timing Of The Pcsok Signal (From Run To Stop) - Hitachi S10VE User Manual

11.7 State signal timing

11.7.1 PCsOK signal

The PCsOK signal is a signal that turns on the contact output when a ladder program is set to RUN.
ON output is enabled when the RUN/STOP switch of the CPU module and the LADDER RUN/STOP switch
are set to RUN.
Figures 11-12 and 11-13 show the output timing.
■ Going from STOP to RUN
LADDER RUN/STOP switch
PCsOK output signal
Ladder program

Figure 11-12 Output timing of the PCsOK signal (from STOP to RUN)

Note: If LADDER MODE is set to "SIMU", the PCsOK signal will not turn ON even when the LADDER
RUN/STOP switch changes from STOP to RUN (SIMU).
■ Going from RUN to STOP
LADDER RUN/STOP switch
PCsOK output signal
Ladder program

Figure 11-13 Output timing of the PCsOK signal (from RUN to STOP)

STOP
RUN (NORM)
OFF
Within
15 ms
Within one
sequence cycle
STOP
RUN (NORM)
ON
Within
15 ms
Within one
sequence cycle
11-17
ON
Operation
Stop
OFF
Operation
Stop
11. Operation