Operation; Starting And Stopping The Cpu Module - Hitachi S10VE User Manual

11. Operation

11.1 Starting and stopping the CPU module

The running of user programs and remote I/O communications are performed according to the settings of the
S10VE CPU module.
(1) Operating status of user programs and remote I/O communications according to the settings of the CPU module
Table 11-1 shows the status of user programs and remote I/O communications according to the settings of the
S10VE CPU module.
Table 11-1 User programs and remote I/O communications according to the settings of the
Power switch
No. on the power
RUN/STOP
module
1 OFF --
2 ON STOP
3 ON STOP
4 ON RUN
5 ON RUN
6 ON RUN
#: Specify the settings in the software according to BASE SYSTEM/S10VE.
• To start the CPU module by using a reset, change the CPU RUN/STOP switch from the STOP to the RUN
position.
• To stop the CPU module when the RUN LED is on, change the CPU RUN/STOP switch from the RUN to
the STOP position.
Note: If you want an initial start when the RUN LED is on, change the CPU RUN/STOP switch from the
RUN to the STOP position, and then to the RUN position again. If the software has issued a remote
STOP request, you cannot change the CPU RUN/STOP switch to the RUN position. Use the
software to issue a remote RUN request.
(2) Starting and stopping via remote control
You can start and stop the system over the network by using a PC. For details on the specific procedure, see the
software manual for the application you are using.
• S10VE Software Manual Programming Ladder Diagram System for Windows® (manual number SEE-3-
121)
• S10VE Software Manual Programming HI-FLOW for Windows® (manual number SEE-3-122)
• S10VE Software Manual Operation Ladder Diagram System for Windows® (manual number SEE-3-131)
• S10VE Software Manual Operation HI-FLOW for Windows® (manual number SEE-3-132)
• S10VE Software Manual CPMS General Description and Macro Specifications (manual number SEE-3-
201)
CPU module settings
CPU LADDER
RUN/STOP
switch switch
--
STOP
RUN
STOP
RUN
RUN
CPU module
LADDER
C
operation
language
#
mode setting
-- Stop
-- Stop
-- Stop
-- Operation Stop
NORM Operation Operation Operation Operation
SIMU Operation Operation Operation Stop
11-1
User program
Ladder HI-FLOW
Stop Stop
Stop Stop
Stop Stop
Stop
11. Operation
Remote I/O
communication
Stop
Stop
Stop
Stop