Hitachi S10VE User Manual page 413

13. Troubleshooting
● Interface information
Information about interfaces in use is displayed. (Information about both channels is displayed.) From
the Display Status of Network window, click the Interface tab, and then click the Refresh button.
Display example
UNIT NO. 1:
slot = 0
kind =EPORT
MTU = 1500
IP address
netmask
broadcast address = 192.168.1.255
output request count
output count(success)
output discard error count = 0
output error count
deliver count
input count
input discard error count
input error count
UNIT NO.: 1 = Channel 1, 2 = Channel 2
slot: Slot number
kind: Type (EPORT fixed)
MTU: Maximum number of transmitted bytes
IP address: IP address
netmask: Netmask
broadcast address: Broadcast address
output request count: Number of accepted requests for message transmission (not used)
output count(success): Number of successful message transmissions
output discard error count: Number of failed message transmissions due to insufficient memory
output error count: Number of failed message transmissions reported by hardware
deliver count: Number of deliveries of transmitted messages to the user (not used)
input count: Number of message receptions reported by hardware
input discard error count: Number of failed message receptions due to insufficient memory
input error count: Number of failed message receptions reported by hardware
= 192.168.1.11
= 255.255.255.0
= 0
= 532
= 0
= 0
= 622
= 0
= 0
13-68