Configuration Of Ethernet Parameters Using Eh-Eth2 Configurator; Setting Procedure - Hitachi EH-150 Applications Manual

5.2

Configuration of Ethernet parameters using EH-ETH2 Configurator

Communication parameters are configured or confirmed via EH-ETH2 Configurator.
Table 5.2
(1) Ethernet parameters
IP address of self station
Configuration of destination for diagnostic
Configuration of task code port
(2) ASR parameters
ASR General Information
ASR connection setting
ASR I/O Area setting
(3) Downloading/Uploading of setup file
(4) Other
Information of firmware version
[Reset Module] button
5.2.1

Setting procedure

Figure 5.1 shows the outline of setting procedure.
Chapter 5 Configuration of Communication parameters
The list of the items can be configured by EH-ETH2 Configurator
Items
(*1)
Start Setting
Connect PC and EH-ETH2 with LAN
cable and HUB.
Confirm the network setting of PC
After changing the dip switch on
EH-ETH2, power on PLC.
Open EH-ETH2 Configurator on PC.
Set Communication Parameters
After changing the dip switch on
EH-ETH2, reset EH-ETH2.
Finish setting
*1: Please install EH-ETH2 Configurator beforehand.
The Internet access is required for installation of EH-ETH2 Configurator.
Figure 5.1 The outline of setting procedure
5-2
Section number to refer
Section 5.2.7
Section 5.4.1 to 3
Section 5.4.4
Section 5.2.6
Configuration mode
Normal operation mode