Replacing The Heat Exchanger Fan In The Filter Cubicle - ABB ACS880-37LC Hardware Manual

￭

Replacing the heat exchanger fan in the filter cubicle

WARNING!
Wear protective gloves and long sleeves. Some parts have sharp edges.
1. Repeat the steps described in section
you start the work.
2. Remove the shrouding in front of the fan (if any).
3. Disconnect the fan wiring.
4. Remove the four screws and pull the fan unit out.
5. Remove the two screws in front of the heat exchanger.
6. Install a new fan in reverse order.
Electrical safety precautions (page 17)
5
4
Maintenance 123
before