Kemppi X5 FastMig Series Operating Manual page 49

8. Follow the previous steps in reverse to install the wire feed rolls. Align the cut on the drive rolls' bottom with the
pin on the drive shaft.
9. Reattach the mounting caps and mounting pins to lock the drive and pressure rolls into their places.
10. Close the locking arms and lower the pressure handles on the feed rolls. Refer to "Installing and changing wire"
on page 41 for more information on the wire installation.
11. Close the wire feeder top cover.
© Kemppi
50
X5 FastMig
Operating manual - EN
1920960 / 2039