Kemppi X5 FastMig Series Operating Manual page 28

Depending on your X5 FastMig setup, two different rear fixing plate options are available. Both include an interface for
the interconnection cable strain relief mechanism, but the longer one acts also as a cart connection bracket.
3. Slide the wire feeder from front to back until the bar in the back locks into the locking mechanism on the power
source.
4. Ensure that also the front of the wire feeder is locked in position (to the front fixing plate edge).
The rear locking is released by pulling the locking mechanism lever:
© Kemppi
29
X5 FastMig
Operating manual - EN
1920960 / 2039