X5 Manual Control Panel (X5 Fp 300R) - Kemppi X5 FastMig Series Operating Manual

For replacing the wire feed rolls, refer to "Installing and replacing feed rolls" on page 47.
For replacing the wire guide tubes, refer to "Installing and replacing wire guide tubes" on page 51

1.4 X5 Manual control panel (X5 FP 300R)

This section describes the controls and features of the X5 Wire Feeder 300 Manual control panel (membrane panel).
1. Left control knob
2. Right control knob
3. Trigger logic selection (2T/4T)
4. Process selection (MIG/MMA/Gouging)
5. Home button (default welding mode)
6. Weld data button
7. Settings button
For using the control panel, refer to "Using X5 Manual control panel" on page 63.
© Kemppi
14
X5 FastMig
Operating manual - EN
1920960 / 2039