Minarc T 223 Acdc Control Panel - Kemppi Minarc T 223 ACDC Operating Manual

3.2 Minarc T 223 ACDC control panel

This section describes the controls and features of the Minarc T 223 ACDC control panel.
You can access different parameter adjustments and setups by pressing the physical buttons (2-7 in the figure below).
Once the adjustments have been made, exit by pressing the same button again or by pressing another button.
General
1. Control knob
>> Adjustment and selection (for more information, refer to "Main view" on page 30)
2. Memory channels button
>> Short press: Changes memory channel
>> Long press: Saves parameters to memory channel
3. Welding parameters and TIG HF ignition button
>> Short press: Welding parameter adjustment
>> Long press: Toggles between TIG HF ignition ON / OFF (with AC TIG, the HF ignition is always on)
4. Trigger logic button (TIG, cleaning and polishing processes)
>> Short press: Toggles between 2T and 4T trigger logic functions
>> Long press in 2T: Sets 4T and Minilog on
>> Long press in 4T: Sets Minilog on
>> Short press when Minilog is on: Sets Minilog off and changes trigger logic to 2T
>> Long press when Minilog is on: Sets Minilog off but trigger logic stays in 4T
5. Current mode button
>> Short press in TIG: Toggles between DC- and AC current modes
>> Long press in AC current mode: AC balance adjustment
>> Short press in AC balance adjustment mode: AC frequency adjustment
>> Short press in MMA: Toggles between DC- and DC+ current modes
6. Pulse TIG button
>> Short press: Toggles between pulse TIG welding ON / OFF
>> Long press when pulse TIG is on: Pulse frequency adjustment
7. Process and remote control button
>> Short press: Toggles between TIG, MMA, cleaning and polishing processes
© Kemppi
28
Minarc T 223 ACDC
Operating manual - EN
1922350 / 2413