6.
Place the cable's strain relief block to the slot on the wire feeder and secure it in place by closing and locking the
strain relief latch.
7.
Close and lock the cable cabinet door.
When connecting the cables to the wire feeder, route the cables neatly so that the cable cabinet door closes properly.
The interconnection cable heats up during welding. The wire feeder's cable cabinet door must be kept closed when weld-
ing, and the cables must be handled with caution if the cabinet door is opened right after welding.
© Kemppi
35
X5 FastMig
Operating manual - EN
1920960 / 2039