Disabling The Service Concept - Siemens SIMATIC KP400 Comfort Operating Instructions Manual

Commissioning the device
4.2 Using the service concept
4.2.3

Disabling the service concept

If you do not wish to continually back up the data of an HMI device on a memory card to
ensure information security, you can disable the service concept.
Procedure
Proceed as follows:
1. Open the Control Panel.
2. Open the "OP Properties" dialog by using the "OP" icon.
3. Open to the "System Card" tab.
4. Disable the service concept with "Disable & Reboot".
5. Restart the HMI device.
Result
The service concept is disabled. You can enable the service concept again at any time in the
"System Card" tab. If you do not wish to enable the service concept again, protect the
Control Panel with a password.
See also
Changing password protection (Page 86)
64
Operating Instructions, 03/2012, A5E03404994-02
Comfort Panels