Closing The Project - Siemens SIMATIC KP400 Comfort Operating Instructions Manual

Requirement
Operating element with the configured infotext is selected.
Procedure
Proceed as follows:
1. Press the <HELP> key.
2. Use the cursor keys to scroll as needed.
3. Close the window with the infotext.
Alternative procedure
Depending on your configuration, infotext can also be called via a configured operating
element.
Refer to your plant documentation to find any additional information on this topic.
6.9

Closing the project

Procedure
Proceed as follows:
1. Use the corresponding operating element object to close the project.
2. Switch off power to the HMI device.
Comfort Panels
Operating Instructions, 03/2012, A5E03404994-02
The infotext for the operating element is displayed.
Note
Switching between displayed infotext
The configuration engineer can configure infotext for an I/O field and the associated
screen. You can switch between two infotexts by touching the infotext window.
Wait for the Loader to open after you closed the project.
Operating a project
6.9 Closing the project
163