Connecting The Power Supply; Fuses For Auxiliary Outlets - Dräger Primus SW 4.5n Instructions For Use Manual

Assembly and preparation

Connecting the power supply

The mains power voltage must correspond to that
specified on the rating plate at the back of the work-
station:
100 to 240 V
Plug the mains plug into the mains power
socket.
LED on the front of the workstation lights
up green.
NOTE
The mains plug must be readily accessible so that
the power supply to Primus can be quickly inter-
rupted if there is a device failure.

Fuses for auxiliary outlets

When using the two-fold socket strip with automatic
circuit-breakers:
If a fuse is tripped (position 0):
Remedy the fault, then press the switch at the
automatic fuse to the position I.
The fuse is active again.
70
When using the three-fold socket strip* with safety
fuses:
1 Remedy the fault, then
2 have the safety fuse replaced by experts.
* Only available in countries with socket outlets conforming
to DIN 49440
Instructions for use Primus SW 4.5n