Parameter Description/Help; Basic Configuration; Introduction - Bosch Rexroth IndraMotion MTX micro Easy Setup Manual

DOK-MTXMIC-EASY*******-CO06-EN-P
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
8.2.5

Parameter description/Help

Parameters are explained under "information":
8.3

Basic configuration

8.3.1

Introduction

Checking the drive assignment
Fig. 8-6: Parameter description and help
The basic setting of the machine is made and/or checked in the "configura‐
tion parameters".
Proceed as follows:
1. Configuration parameters
2. Basic NC configuration (MAIN)
Open nodes Dr[1] to Dr[4].
Check the assignment of the drives to the machine (see fig. 4-2):
1. Number of NofCh channels (usually one channel)
2. Number of NofDr NC axes (4 in case of HCQ and 3 in case of HCT con‐
trollers)
3. Number of NofDrNodes drives
4. Node SpFunc indicates that this drive is a spindle
Bosch Rexroth AG 91/177
NC parameterization