Bosch Rexroth IndraMotion MTX micro Easy Setup Manual page 8

6/177 Bosch Rexroth AG
About this documentation
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
For each function, the following information is provided:
● Purpose or area of application
● Prerequisites/restrictions on use
● Interference options
Numerous functions affect several domains at the same time (machine pa‐
rameters, NC functions for programming, interface signals, etc.). Thus, many
functions can also be described completely or partially in other manuals of
this product.
Refer to the respective manual.
The following manuals supplement this manual:
● Machine parameters: "Rexroth IndraMotion MTX Machine
Parameters"
● NC and CPL functions: "Rexroth IndraMotion MTX Program‐
ming Manual"
● Interface signals: "Rexroth IndraMotion MTX PLC Interface"
Furthermore, have the drive documentation at hand.
You require good knowledge of the
● standard user interface of the control
● Windows user interface of the PC control panel
● tools for the machine parameter configuration
These tools can modify the control configuration. Therefore, you have to be
familiar with all required tools!
CAUTION
Thus, only qualified staff that is sufficiently trained may start and operate the
system and set or modify configuration parameters!
The personnel also has to be able to detect the risks resulting from changing
parameters and the inherent general risks of mechanical, electrical or elec‐
tronic equipment.
Incorrect or unintended use by insufficiently trained or untrained staff can
cause serious damage to the equipment! Bosch Rexroth is not liable for any
of those damages and consequential damages caused.
DOK-MTXMIC-EASY*******-CO06-EN-P
Due to an incorrect or unintended use caused
by insufficiently trained or untrained staff, se‐
rious damage to the machine, loss of data
and even personal injury can result!