Diagnostics (Machine Status Display); General Information; Mza Message Display - Bosch Rexroth IndraMotion MTX micro Easy Setup Manual

DOK-MTXMIC-EASY*******-CO06-EN-P
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
S1, S2
7.4

Diagnostics (machine status display)

7.4.1

General information

7.4.2

MZA message display

The S1, S2 functions serve to program the speed command value for spin‐
dles 1 and 2 and to automatically transfer the value to the spindle.
S The S-function has the same behavior as the S1 function, with S200 corre‐
sponding to S1=200.
Errors, warnings and messages displayed in plaintext during ongoing opera‐
tion help to reduce standstill and startup times. The machine status display
(MZA) allows generation of a total of 2048 messages from the PLC program.
The NC user interface signals the corresponding diagnostics to the user in
plaintext. Each diagnostics message is controlled by a separate message bit
in the PLC program. The MTX micro saves the displayed MZA diagnostic
messages in a logbook in the CNC.
A diagnostics message can be displayed as
● an error (red),
● a warning (yellow), or
● a note (green) on the user interface
Currently existing messages are displayed in the diagnostics bar on the HMI
screen (1). This bar is visible on all screens. If active at the same time, sever‐
al messages are displayed alternately in the diagnostics bar.
In the "Diagnostics" operating area, all active messages and diagnostic texts
are displayed.
Bosch Rexroth AG 81/177
PLC commissioning