Bosch Rexroth IndraMotion MTX micro Easy Setup Manual page 177

DOK-MTXMIC-EASY*******-CO06-EN-P
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Serial commissioning........................................ 150
Service hotline.................................................. 171
Setting communication parameters.................... 64
Communication errors with the MTX micro.... 68
Communication test....................................... 67
Setting the IP address of the PC.................... 66
Setting the IP address on the MTX micro...... 65
Setting important drive parameters
Mechanic axis setting................................... 128
Setting spindle data..................................... 129
Setting the reference position...................... 129
Setting the communication parameters
Setting the IP address of MTX micro in
the IndraWorks project................................... 64
Setting the IP address of the PC......................... 66
Setting the IP address on the MTX micro........... 65
Signal words....................................................... 10
Software installation............................................ 59
Suggestions........................................................ 12
Support............................................................. 171
Symbols used..................................................... 12
System overview................................................. 13
Performance.................................................. 14
T
TargDNr............................................................ 158
TargEd.............................................................. 158
Target groups........................................................ 5
Testing the communication................................. 67
Timeout............................................................. 157
U
Unintended use................................................... 20
Unintended Use
Consequences, non-liability........................... 19
V
VDP80.1FGN-C1-NN-EN for turning machines.. 38
VDP80.1FHN-C1-NN-EN for milling machines... 37
W
Warnings............................................................. 10
Wiring diagrams................................................ 163
Wiring diagram for MTX micro with HCQ
(3-axis configuration)................................... 164
Wiring diagram for MTX micro with HCQ
(4-axis configuration)................................... 163
Bosch Rexroth AG 175/177
Index