Unintended Use - Bosch Rexroth IndraMotion MTX micro Easy Setup Manual

20/177 Bosch Rexroth AG
Important instructions on use
3.2

Unintended use

IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
This additionally requires I/O components for the integrated PLC
which - together with the actual CNC - control the machining proc‐
ess as a whole and also monitors this process with regard to
technical safety.
It may only be operated with the explicitly specified hardware
component configurations and combinations and only with the
software and firmware specified in the appropriate documenta‐
tions and functional descriptions.
The Rexroth IndraMotion MTX provides the perfect CNC system solution for
cutting and forming for the following technologies:
● Turning
● Milling
● Drilling
● Grinding
● Bending
● Nibbling
● Punching
● Contour cutting
● Handling
The use of the Rexroth IndraMotion MTX in application areas other than
those specified or described in the documentation and technical data is con‐
sidered as "unintended".
The Rexroth IndraMotion MTX must not be used if ...
● it is subjected to operating conditions not corresponding to the specified
ambient conditions. Operation under water, under extreme temperature
fluctuations or under extreme maximum temperatures is prohibited.
● the intended applications have not expressively been released by Bosch
Rexroth. Therefore, please read the information given the general safety
instructions!
● The Rexroth IndraMotion MTX may not be used in systems or machines
connected to the internet via an unsecure network connection Other‐
wise, malfunctions or a control failure can result due to unauthorized ac‐
cess.
DOK-MTXMIC-EASY*******-CO06-EN-P