Adjusting The Basic Setting Of The Drive - Bosch Rexroth IndraMotion MTX micro Easy Setup Manual

106/177 Bosch Rexroth AG
Commissioning the drives
9.3

Adjusting the basic setting of the drive

Linear axis
Rotary axis, spindle
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
After the basic parameters of the drives have been loaded, there are a few
essential parameters that must first be set.
1. Feed constant: Distance traveled by the axis while the motor shaft
makes one revolution
2. If a mechanical gear is installed between the motor and the load, the
gear ratio must be entered via "Input revolutions of load gear n1" and
"Output revolutions of load gear n2"
Fig. 9-4: Basic setting of the axis – linear axis
There is no feed constant for rotary axes and spindles so that only one load
gear must be defined:
1. "Input revolutions of load gear n1" and "Output revolutions of load gear
n2"
2. Please note that the gear stages must each be entered separately for
spindles with gearshift unit
Fig. 9-5: Basic setting of the spindle – mechanical gear
DOK-MTXMIC-EASY*******-CO06-EN-P