Testing The Communication - Bosch Rexroth IndraMotion MTX micro Easy Setup Manual

DOK-MTXMIC-EASY*******-CO06-EN-P
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
6.3.5

Testing the communication

Fig. 6-7: Configuring the IP address in the PC
To ensure that the IP address is used, you should restart the PC
after having set the address. Do not forget to change the address
again before connecting the PC to a different network.
We recommend that you note down the original network settings of the PC
before changing them.
Original PC settings:
● IP Address →__ .__ .__ .__
● Subnet Mask →__ .__ .__ .__
● Standard gateway →__ .__ .__ .__
Test the communication after the IP addresses have been configured.
The following description shows the steps required for testing communication
between the system and the PC:
1. After a project has been opened, communication mode initially is set to
"offline". For example, the "NC configuration" and "NC file system" no‐
des are gray, i.e., "inactive"
2. Click on the icon (blue) to switch communication with the MTX micro to
online
3. Communication with the MTX micro is checked
4. After having switched communication to online, the "NC configuration"
and "NC file system" nodes are activated
Bosch Rexroth AG
Software installation and basic projects
67/177