Bosch Rexroth IndraMotion MTX micro Easy Setup Manual page 98

96/177 Bosch Rexroth AG
NC parameterization
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Fig. 8-11: Schematic diagram 2
Name
Positive max. traversing range
Negative max. traversing range
Maximum axis velocity
Maximum acceleration
Tab. 8-4: NC parameter axes
Fig. 8-12: Parameter setting for axes: Traversing range, velocity, acceleration
Two traversing range limits TrvLim[1] and TrvLim[2] can be defined for each
axis. Switching between these two traversing ranges can be controlled via
the PLC. If only one traversing range is required, it is recommended to set
the two traversing ranges to the same limits.
DOK-MTXMIC-EASY*******-CO06-EN-P
Path
AX/Dr[i]/Pos/TrvLim[1..2]/PoTrvLim
AX/Dr[i]/Pos/TrvLim[1..2]/NeTrvLim
AX/Dr[i]/Vel/MaxVel
AX/Dr[i]/Acc/MaxAxAxx
I1
I2