Hoses And Cables Routing; Front Wheel Hub - JLG TOUCAN 10E Service And Maintenance Manual

SECTION 4 - CHASSIS MOUNTED COMPONENTS

Hoses and Cables Routing

ROUTE AND STRAP STEERING SENSOR HARNESS AS SHOWN
ON FIGURE 4-13. THIS IS TO PREVENT THE CABLE FROM BEING
PINCHED/DAMAGED BY THE WHEEL WHEN FULLY STEERED TO
THE RIGHT.
Figure 4-11. Hoses and Cables Routing
4-6

4.4 FRONT WHEEL HUB

Figure 4-12. Front Wheel Hub - Installation
1. Hub Cap
2. Cotter Pin
3. Spindle Nut
4. Washer
5. Outer Tapered Roller Bearing (a)
6. Outer Bearing Race (a)
7. Wheel Mounting Hub (a)
8. Inner Bearing Race (a)
9. Inner Tapered Roller Bearing (a)
10. Hub Seal
NOTE: (a) Bearing race (6, 8) are press fitted to wheel
mounting hub (7) and are only available for service
as a complete hub assembly.
Also before installing or re-installing the inner and
outer taper roller bearings, be certain they are lubri-
cated (packed) with multipurpose grease.
1. Tighten spindle nut to 40-54 Nm (30-40 ft. lbs.) to
properly seat bearings.
2. Loosen spindle nut completely until it can be turned
by hand.
3. Then finger tighten spindle nut by hand without
rotating the wheel mounting hub.
4. Install cotter pin, if necessary nut may be backed off
to nearest slot, if more than 1/2 of the cotter pin hole
is visible, the nut may be tightened slightly to get the
cotter pin installed.
5. Before installing the hub cap, check wheel hub for
excessive end play.
a. Rotate hub by hand, hub should rotate freely, if
too tight, back the nut off to the next cotter pin
hole.
b. Hub should not be noticeably loose when
moved parallel with spindle centerline.
6. Install wheel, torque wheel per specification in Sec-
tion 4.2.
– JLG Lift – 31210090