Lubrication Chart - JLG TOUCAN 10E Service And Maintenance Manual

SECTION 1 - OPERATING SPECIFICATIONS

Lubrication Chart

Component
1 Swing Bearing Race
2 Swing Bearing Teeth
3 Mast Profiles
4 Lifting Chains
5 Hydraulic Oil
6 Overload System Spring Washers
7 Hydraulic Filter
(*) Filter cartridge part number: 930134
NOTE: Lubrication intervals are based on machine operation under normal condition. For machines used in multi shift opera-
tions and/or exposed to hostile environments or conditions, lubrication frequencies must be increased accordingly.
NOTE: Refer to the corresponding sections in this manual for specific lubrication procedures.
1-6
Figure 1-1. Lubrication Chart
Table 1-13. Lubrication Chart
Number/Type
Lube
Lube Points
2 grease fittings A
By brush B
By brush A
Spray on or by
C
brush
Fill through
D
reservoir cap
By brush E
N/A (*)
– JLG Lift –
1. Swing bearing race
2. Swing bearing Teeth
3. Mast profiles
4. Lifting Chains
5. Hydraulic Oil
6. Overload System Spring Washers
7. Hydraulic Filter
Interval Hours
125 250 1000
X
X Remove old grease first
X Remove old grease first
X Lubricate before first 50 hours of operation
X Check level daily. Change at least every 2 years
X
X Change after first 50 hours of operation
Comments
31210090